height set of hydraulic cutting machine

- Feb 28, 2019-

1 "Clear the debris on the work surface rubber sheet and place the knife mold in the center of the rubber sheet.


2" After the machine is started, set the handwheel to release and turn the "pressure system" to the left position.


3" Rotate the setting switch to the right in the "die setting" direction, and the cutting plate 13 will start to slowly descend until it closes to the die and automatically stops.


4" Push the setting handwheel to the bottom and tighten it. Before the start, the 04 setting switch system (left turn) is turned to the "cut" position.


5" Press the brake switch again, and the cutting plate will immediately rise to the highest position. At this time, the die setting is completed.


18 (1)


Adjustment of the cutting point:

1 After the die setting work is completed, the cut material is placed on the rubber plate, and then the die is placed on the material, and then the feed plate is advanced into the cutting area.


2" Press the 12 cutting switch with both hands respectively. At this time, the cutting plate is lowered and pressurized to the die. After the cutting die cuts the material, it automatically rises to the position before starting to stop.


3" When punching the material, if it is found that the material is not completely cut, adjust the 03 cutting depth controller to rotate the "pressure system" clockwise in the opposite direction; if the die is pressed into the rubber plate too deep, the "pressure system" will be Rotate counterclockwise. The longer the adjustment time, the deeper the cutting depth. Try to adjust until the die is pressed slightly into the rubber plate.


4" Pull the feeding plate out of the cutting area, take out the cut material, and complete a blanking process.