Automatic Cutting Machine Operation Instructions

- Feb 17, 2020-

1. First turn the cutting depth controller (fine adjustment knob) left to zero.


2. Turn on the power switch, press the oil pump start button, and run for two minutes at no load to observe whether the system is normal.


3. Put the push-pull plate, rubber plate, workpiece, and die in the middle of the work table in order.


4. Knife mold setting (knife mold setting).


①. Loosen the knife setting handle, naturally fall to the bottom and lock it.


②. Turn the switch to the right to prepare for trial cutting.


③. Double-click the green button for trial cutting. The punching depth is controlled by fine adjustment.


④. Fine-tuning: Turn the fine-tuning button to lighten left and deepen right.


⑤. Stroke adjustment: Rotate the height controller to increase the right-hand stroke and decrease the left-hand stroke. The stroke can be freely adjusted within the range of 50-180mm (or 50-230mm). During normal production, the above pressure is about 50mm from the top of the die Better.


Special attention: every time you change the die, workpiece or pad, you must set the stroke again, otherwise the die and pad will be damaged.