Automatic Cutting Machine Safety Precautions

- Feb 18, 2020-

① To ensure safety, it is strictly forbidden to put hands and other parts of the body into the punching area during operation. The power must be turned off before maintenance, and wooden blocks or other hard objects must be placed in the punching area to prevent the pressure plate from being released after pressure relief Out of control, causing accidental personal injury.


② In special cases, if the upper platen needs to be raised immediately, you can press the reset button. When stopping, press the power brake button (red button), and the entire system will stop immediately. ③ During operation, the two buttons on the pressure plate must be hit with both hands. Do not change it with one hand or operate by foot. Maintenance: Always keep the inside of the machine clean. The oil filter is cleaned once a month. The hydraulic oil is changed once a year. Before working, pay attention to check the oil level in the machine. When it is lower than the specified liquid level, it should be supplemented with the same grade as the machine. Do not mix hydraulic oil. When cutting materials, the workpiece should be placed in the center of the work area, so that the force is evenly distributed throughout the machine, and the service life of the machine is extended from the surface.