Automatic Cutting Machine To Distinguish Good And Bad Method

- Feb 09, 2021-

First, we need to check the appearance, that is, the basic spray color, to see the appearance is not only the surface layer, but also the interior, cylinder, chassis and workbench, etc.; There is also a need to check the difference between the centrifuge and the old machine.




Two, listen to the sound can also distinguish good or bad, so it is able to determine whether it is a new machine, if it is a new equipment is not noisy, only the motor runs out of abnormal sound, then it proves that there is a problem with the equipment.




Three, there are electrical control box open is generally do not need the key, can be readily opened, so you need to check whether the circuit in the box is normal.




Four, and the test machine need to check whether the operation is flexible, check the production efficiency of the plastic equipment, check how the product quality is after blanking.




How should we install the cutting machine normally? The following automatic cutting machine Xiaobian to talk about you;




First, it is necessary to pay attention to the equipment should be placed on the flat concrete floor, and it is necessary to check whether each part is complete, and check whether all the lines are smooth.




Second, attention should be paid to the cleaning of the equipment to avoid sundries on the work surface of the equipment.




Three, when the injection of hydraulic oil needs to be carried out after the installation of the equipment, the oil level needs to be kept above the oil filter surface.




Four. When accessing the power supply, the device can only be started by pressing the button. The steering of the motor needs to be adjusted well, and the steering of it needs to be the same as the steering of the arrow.