Four Column Hydraulic Die Cutting Machine Operation Precautions

- Feb 01, 2020-

1. When the precision four-column cutting machine is working, the cutter should be placed as far as possible in the center of the upper platen, so as not to cause wear on one side of the machine and affect its life.

2. When replacing the new cutter with a precision four-column cutting machine, if the height is not the same, please reset it according to the setting method.

3. When the operating staff needs to leave the position temporarily, be sure to turn off the motor switch before leaving, so as not to damage the machine due to improper manipulation by others.

4. Please avoid overloading to avoid damaging the machine and reducing the service life.

5. When setting the cutter, be sure to release the setting handwheel first so that the setting lever can contact the cutting point control switch. Otherwise, when the cutter setting switch is turned ON, the setting action cannot be generated. .

6. Please keep your hands away from the cutter or chopping board during the cutting action of the precision four-column cutting machine. It is strictly forbidden to touch the die with your hand to avoid danger.