Instructions For Automatic Hydraulic Press Die Cutting Machine

- Jan 17, 2020-

Instructions for automatic hydraulic press die cutting machine


1. First turn the cutting depth controller (fine adjustment knob) of the automatic cutting machine to the left to zero.


2. Turn on the power switch, press the oil pump start button, and run for two minutes at no load to observe whether the system is normal.


3. Put the push-pull plate, rubber plate, workpiece, and die in the middle of the work table in order.


4. Knife mold setting (knife mold setting).


(1). Loosen the knife setting handle, naturally fall to the bottom and lock it.


(2). Turn the switch to the right to prepare for trial cutting.


(3). Double-click the green button for trial cutting. The punching depth is controlled by fine adjustment.


(4). Fine-tuning: Turn the fine-tuning button to lighten left and deepen right.


(5). Stroke adjustment: Rotate the height controller, increase the right-hand stroke, and decrease the left-hand stroke. The stroke can be freely adjusted within the range of 50-200mm (or 50-250mm). It is appropriate that the above pressure is about 50mm from the top of the die during normal production .