Maintenance Items Of The Automatic Hydraulic Cutting Machine

- Dec 19, 2019-

First, replace the hydraulic oil

The cycle of replacing the hydraulic oil is one year (it can be shortened or extended according to your actual use), and the fuel tank and filter are cleaned while replacing the hydraulic oil. For hydraulic oil, please select the regular brand brand product with the label 46#.

Second, remove dust

Remove dust and foreign matter should be carried out every day (electric dust should be handled by professionals), paying special attention to the sliding and rotating parts. caution! Cleaning dust should be done after the machine has been completely shut down.

Third, the fastening bolt

The fastening bolt is an important part of the maintenance of the cutting machine. If the loose bolt is broken for a long time, it will cause more problems or accidents (it is recommended to do it once every three months).

Fourth, check the lubrication system

The sliding and rotating parts of the cutting machine need to be filled with lubricating oil, and good lubrication is necessary for the operation of the machine, so it is especially necessary to check the automatic lubrication system regularly.

Fifth, check the parallelism of the table

In actual use, it is impossible to cut the die at the center of the cutting machine every time. The long-term center-cutting will cause the parallelism of the cutting machine to deteriorate, thus accelerating the wear of the die and the pad. Regularly check the parallelism of the table top, and you can always grasp the parallelism of the table top of the cutting machine, so as to adjust the die cutting position during use, correct the unevenness, and make the cutting machine use longer to achieve the best performance.