Pay Attention To When Using The Four-column Cutting Machine Die

- Oct 15, 2020-

What should I pay attention to when using the four-column cutting machine die?


1. The form and cause of tool wear


When the four-post cutting machine cuts metal, the tool cuts off the chips on the one hand, and on the other hand, the tool itself is also damaged. The main forms of tool damage are wear and breakage. The former is continuous gradual wear; the latter includes brittle damage (such as chipping, chipping, peeling, crack damage, etc.) and plastic damage. After the tool is worn, the machining accuracy of the workpiece is reduced, the surface roughness increases, and the cutting force increases, the cutting temperature rises, and even vibration occurs, and normal cutting cannot continue. Therefore, tool wear directly affects processing efficiency, quality and cost. There are several forms of tool wear:


Rake face wear


Flank wear


Boundary wear


Judging from the degree of dependence on temperature, the main reasons for normal tool wear are mechanical wear and thermal and chemical wear. The four-post cutting mechanical wear is caused by the scribing effect of the hard points in the workpiece material, and the thermal and chemical wear are caused by adhesion (the bonding phenomenon produced when the tool and the workpiece material contact the distance between atoms), diffusion (the tool and the workpiece The chemical elements on the two friction surfaces face each other, corrosion, etc.).


2. Tool wear process, blunt standard and tool life


As the cutting time increases, tool wear increases. The tool wear process can be divided into three stages:


Initial wear stage


Normal wear stage


Rapid wear stage


If the tool is worn to a certain extent, it cannot be used. This degree of wear is called the blunt standard. The actual cutting time for a new knife (or a re-sharpened tool) from the beginning of use until it reaches the blunt standard is called the tool life.