Why Hydraulic Cutting Machine Blanking Or Cutting Materials?

- Jan 27, 2021-

First of all, looking for blanking inability to cut continuous material fault where the problem? The current hydraulic cutting machine is now the four pillars, usually with a pressure gauge, the pressure gauge according to your machinery and equipment ton set, so check the pressure gauge display is very low? If the pressure gauge display is low, the relief valve can be adjusted to effectively increase the blanking pressure.




Secondly, if the pressure gauge mentioned above shows normal, it is ok to check whether the oil pump in the cylinder is damaged. Is the filter net of hydraulic oil blocked, so that the oil pump cannot be inhaled? Then there is the problem of hydraulic cutting machine setting. Is the stroke setting of the die too low? The cutting depth controller can be adjusted. The longer the adjustment time is, the deeper the cutting depth will be.




Hydraulic cutting machine blanking unable to cut continuous material equipment problems are basically listed, can be solved according to the actual situation, of course, in addition to the equipment itself, operation problems can not be ignored. If the material is seriously overloaded, it is beyond the capacity of the cutting machine and equipment. Therefore, the human problem cannot be ignored, and the machine will have its bottom line, so the correct operation is better maintenance of the machine.